JonP925

I'm trying to figure out how the hi/lo switch works on my 2002 Zx6r. I want to have just low beams for my new hid projectors on my new headlight assembly I am trying to install on my bike.

I was told by Jim from easternbeaver.com that I can have my hi/lo act as an on/off switch which I want to do so I can flip it on after startup of my bike.

I was told I can wire this relay kit (has a pos and neg wire at the end of the relay kit) directly to my lo's wire on the switch. Anyone have any idea which wires from the hi/lo switch is the lo's wire I need to connect to? Do I connect just the ground to the lo and wire the positive wire to the battery terminal?

JonP925

If this helps, I have to connect the blue wire from bulb 1's connection to the lo's output on the hi/lo switch from the non h4 relay kit on here:Motorcycle Non-H4 Relay Kits, cheap Worldwide Shipping anyone have an idea how I would go upon this?

I was told by Jim on easternbeaver to connect the positive and negative wires from both projectors ballast and connect those wires altogether to the pos and neg from bulb 1's wires as well, so It can act together as an on/off switch