Kawasaki Ninja ZX-6R Forum banner

Reaction score
157

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews Media Albums About

  • · Registered
    Joined
    ·
    1,144 Posts
    The system says you have chosen not to accept private messages so can't send details. Best to.ask 4htrs or
    corkoli

    · Registered
    Joined
    ·
    1,414 Posts
    i just got arm but not sure if i need to get some more parts,not sure what bits to use.do i use j2 wheel axle and also do i use j2 swingarm pivot shaft and spacers ?or do i use the zx636 06 swing arm parts?i want to use my j2 wheel aswll any help would be spot on,i got a mate who is going to do me my spacers ect,any help would be spot on

    · Registered
    Joined
    ·
    1,414 Posts
    hi mate i just pm you not going through im after some advice about swingarm mod on j2

    · Registered
    Joined
    ·
    17,930 Posts
    The yellow sync tool is Mercury filled, so no need to calibrate before you can use it.
    Its really the best one to have.

    I only wish I had been privy to this info when I got mine.

    · Registered
    Joined
    ·
    17,930 Posts
    Yeah thats it, DavidReaper found one (new( in a shop for $30.00.
    Thats the one I use, But if you can find one of there older models with the mercury, Its the best one to have.

    Motion pro used to make, But replaced it with this thing, However there are still a few to be had.
    If you could find one(there yellow in color) grab it.

    · Registered
    Joined
    ·
    17,930 Posts
    "Yep I test fitted it and it touched so then took 3mm off the back and now clears the rotor by 2mm.."

    Hey Mate you may want to take a bit more off the bracket where it fits to the caliper.
    I had to on mine last week.

    Check to be sure your pads are not dragging on the rotor to much.
    If its not getting hot, then your proly ok.

    · Registered
    Joined
    ·
    17,930 Posts
    Yeah I did, But I recommend you test fit before you do it.
    You may not have to.
    Just watch that the caliper is riding on the rotor as it should.
    Spin the wheel, If all is good, Then your good to go.

    · Registered
    Joined
    ·
    11,641 Posts
    It's the middle of the night there or super early in the morning yer?

    · Registered
    Joined
    ·
    17,930 Posts
    Oh right, & I just sent you that message too.
    Oh well i was still thinking about your swinger swap.

    Just failed to make the connection. I'm slooowwww.

    · Registered
    Joined
    ·
    17,930 Posts
    ha we are one post away from having the same # of post.
    Your at 10,600 dead. I'm on 10,599. LOL!
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top